Double Balloon Nozzles

There is a difference in double balloon nozles, since there is a type where the 2 balloons are inflated at the same time ( made by Rüsch and mostly on the european market), which i would not recommend, since any preasure exterted on your sphincter will deflate the inner balloon and transfer the air to the outer balloon, which would make the tube pop out, this happened to me once. So i recommend to buy only the ones with 2 seperate inflating channels.

I use a 750 cc silicone double balloon cath. Placing it is uncomfortable; it's long and difficult to thread into my sigmoid (the cath tip is pretty stiff and long). The instructions that came with it recommend no more than four pumps. Such bullshit. Inflating to 8 or 9 pumps results in a good seal, but ouch, it is uncomfortable. Inflating and observing the balloon (not in use of course) reveals that when inflated, the balloon curves the catheter. Not sure this is a defect or it's inherent in the design. Susie's note has sparked my interest in contacting customer service.

In hindsight, I should have ordered a smaller balloon size. I may try a latex catheter.

I realize this restates much of Susie's post. My contribution is from one who has difficulties with a particular size cath.

Hats off to Susie: once again, she adddresses the question perfectly.

Yes, 500 cc certainly suits me better than 750 whic , surprisingly does leak

No to dbl balloons.....single balloon ezm barium nozzle gives the best lockup and feeling for me. used all the others and they leak.

I prefer the standard double balloon rectal catheter. It is durable and reliable. Plus it feels SO good!

Oh dear, I just popped the outer balloon on my 500 cc one! sad end to Easter. I can still use it as a single balloon one though but it doesnt feel as secure! good clenching from now on!

I use nylon zip ties on all of my connections. Try to find the ties that have heads with rounded corners, not the sharp square-cornered ones. Cut the excess tail off with a razor blade (carefully!) and trim it so that there is no sharp stub sticking out. You can also sand out any poking edges with a high grit paper, 800 or 1000.

I don't know which is best, but I just had one used on me for the first time Saturday. I am hooked. It just made it so much easier to hold. I don't know if I was supposed to, but after the inner and outer balloons were inflated, I pushed down as if trying to expel the inner one, until it was seated as far as it was going to go. From there on, it is just a nice full feeling, with no urgency to have to release. I was able to enjoy the cramping as the enema went higher and higher. Not that I was going for volume, but I was trying to please my new friend, I took 3 and 3/4 qts. that way. I only had to quit when it up under my ribs and started pushing on my lungs, making me feel, not nauseated but as if I were going to vomit anyway.

I have the 750/250cc double model. It is just a little too large. I would likely moreso enjoy the 500/250 version.

Jimmy

I have the 750/250 silicone nozzle and it's definitely too big and too long! Inserting it takes a while because the tip and part of the balloon wind up in my sigmoid colon. Not comfortable!

The 750/250 Silicon is very long. Almost too long. It does get big! It is comfortable to insert and flows really well. I have a one way valve and will disconnect and move around with it inflated. The 500/250 would have been a better choice for me.

I feel vindicated in my decision to go the DIY route, after finding the price points of the 'store-bought' versions exorbitant. Using an assortment of copper pipe, brass tubing (Silver soldered) and latex tubing, I've built two double balloon nozzles so far as I continue to refine the design. Obtaining thin wall latex tubing was the difficult part of parts/material procurement. Ebay to the rescue! Although each nozzle takes the better part of a Saturday to fabricate, the balloons are replaceable with a bit of effort. My father was a machinist; I guess that the DIY urge/talent must be genetic. On the next build I'll allocate the time to conduct photodocumentation of the process. Hey! I believe I'll go test the latest iteration!

I guess I'll just stick with my trusty barium nozzle rather than have an expensive balloon nozzle fail after only a few uses.

Definitely double balloon rectal catheter is better. It's just so humiliating for her to have her anus completely controlled - both balloons fully pumped up, and forcibly injected.

I wouldn't necessarily classify it as a weird sensation (maybe the first time), certainly a different one though.

For me the good feelings begin when the balloon "pops" inside and rectum clamps down on the tube. Then there is the inflation (swoon).

Not being into the messy side of our sport I am in full agreement with Di that there is a certain sense of release knowing that an accident is not going to be possible while using the double balloon nozzle. Also since you no longer need to spend all of your effort clamping down on the tube with each wave you are able to relax a bit more, concentrate on the feelings and just let things happen.

There is also no question Noz's control factor is often in play with retention device usage. Guess it all depends on what mood you & your playmate are in at the time. 😁 😮 😶

Cheers,

SirInge

I'd appreciate some tips on using a double balloon rectal catheter. Does it tend to fold back on itself the way some colon tubes do or does it keep its shape well enough for easy entry?

From experience I've found little difficulty inserting a double balloon rectal catheter provided that my hands are dry (free of lubricant) . You obviously need a non petroleum based lube on the nozzle. I've had no problem with it folding back on itself. If you find that a problem try inflating the front balloon with a little air (half a pump) before insertion....makes for an exciting insertion.

Care - Hmmmh - Yes these expensive little toys need lots of TLC. Be sure to use only water based lubes on them, wash them and dry them THOROUGHLY after each and every use. I have just switched from a latex to silicone double balloon rectal catheter and will be really interested to see how much more resilient it is than the latex type.

Dry hands definitely! It shouldn't fold back on you like a colon tube either. As far as those who experience them breaking, I have to wonder exactly how much some of these are being inflated. They only need to be inflated enough to block the water from leaking... it doesn't have to be the size of an orange!!

In 6 years of giving enemas, I can say that a common (not ALL) theme with a lot (not ALL) men is bigger, bigger, bigger. Bigger nozzles, more water. They like to challenge themselves. I've inserted a double balloon rectal catheter, inflated it to a comfortable degree where I know there will be no leaks but it's never enough.

Unlike colon tubes which can fold back on themselves fron deep insertions,the baloon nozzles are not inserted deep enough to double up.If you're concerned with overinflating,try counting the amount of pumps on your inflater before the insertion so you can see the size of the inflation of the baloon.

Possibly Waterman43 is under the misconception that both balloons go on the inside. Made that mistake myself with my first double balloon rectal catheter back (to) many years ago when I was young & "uninformed". 😁

Since only the first balloon goes inside I don't see that there is much chance of it folding back on itself, never been a problem for me anyway. I think unless you happen to be fully crammed up inside to start with it shouldn't be an issue for you.

Cheers,

SirInge

Thanks for the tip on "rounding the bend." I use a silicon colon tube along with a higginson's pump but never thought of doing a "pump and push."

Tomorrow morning I might just give this a try. If it works, I'll send you another round of thanks.

I'd read else a tip about double balloons to place a condom, with the end cut off, over the two balloons to make insertion easier.

^^^^ Actually, a condom may come off because it is so thin and flexible. What has worked well for us on balloons of double balloon rectal catheter, is to use a large party balloon and cut the tiniest tip of the end off. Then a little water soluble lube on the double balloon rectal catheter and pull the balloon over the balloon. Since the party balloon is thicker than a condom, it stays in place fairly well on the double balloon rectal catheter. This has two side benefits. One is that you get to see a double balloon rectal catheter in many different colors, and the other is that it keeps most of the feces off the double balloon rectal catheter, so it cleans up easier. Do we do this at home--no, but it does work.

Hi All, and many thanks for your helpful suggestions.

As a rather newcomer to this site I thought I would report on my followup of this helpful and interesting information.

I seem to have a lot of trouble getting the enema to flow while holding by anus tight enough around various nozzles I have tried in the past to prevent leakage, but when I relax my internal parts, the enema flows in nicely, but also leaks out.

Today, with great anticipation, I received my first double balloon nozzle from BethTyler.com. From the various posts here, I decided to go with the 250/250cc latex style with the 2 inflation bulbs. Although I want to try it out right away, I will have to wait until tomorrow. :'( I plan to start with a mild Castile's 2 Qt clean out, and then go on to the exciting part. I also recently got a 4 qt bag from BethTyler/LindaMarie onto which I will hook up the balloon nozzle and let the 'flow begin'. 😃 After this first trial run with this nozzle, I plan to try the "warm bath tub" for a relaxing session.

I'll be sure to post a new not to let you know how everything came out (pun intended). 😉

PS., Can anyone tell me how to get my 'Profile" to show up. I have tried sending this message to the site, but no answer.

For me, the best feeling is JUST after 3-4 pumps to the balloon inside my ass. Ass the first balloon is slipping further up my rectum, I can feel the second (uninflated ballon) just pressing up against my anus. I then grab the second bulb and give a goood, slow, hard squeeze and feel my ass sealing up. The sound and stretching silicon is wonderful. It feels like my ass is blowing a bubble. I love watching the outer balloon grow and spreading my butt cheeks.

Obviously, the standard response is always like "awesome" or "amazing" and that's just fine, but to be brutally honest, it feels like a REALLY big fart that's just stays "there". The second balloon when inflated quite literally spreads your ass hands free. It feels and looks like your asshole is blowing a bubble like you would with gum. Watching myself in the mirror do that really is a turn on.

And yes, you don't have to have a hose connected to the nozzle. 😁

Balloon nozzles are wonderful, just don't get one that' too big. I bought a 750CC and think now 500 would be more comfotable.

I'm trying to get up enough nerve to try a double balloon but thought about how it would be difficult to keep water in the main channel/tube while pushing in the first balloon.

Any tips on how to "keep it all together" while inserting the inside balloon so not much--or no!--air is also pumped inside?

Care to describe the different sensations involved compared to using just a nozzle or colon tube?

Your thoughts are unfounded.

You connect and use it just like a regular nozzle. the balloons simply hold the water inside you.

Hi unsure, Sure they are great. I had wanted one for many years, but thought they were too expensive. I just got mine 2 weeks ago and it was really nice the first time out of the box. I am planning to have my next double balloon tonight, and am really excited at the anticipation.

I got the latex 250/250 cc, about 2 inches in diameter each. It was a pleasure not to have to worry about leaks from my ass while able to relax and just let to flow fill me up without almost any cramping.

Just hook up the nozzle with the usual clamp on the enama tube, and then run some of the water into a low place, like shower or tub, to get any air out of the tubing. Then use a good amount of KY to lube up the first (inner) balloon, wash off the lube from hands so you can get a good grip on the outer balloon, bend over or on hands and knees, and insert the nozzle into a relaxed anus. Push the first balloon only into your ass, and then pump the air bulb the recommended amount, usually 4 full squeezes to inflate the inner balloon, then pump up the outer balloon.

You can then change to any position you like (lots of suggestions on this site) and enjoy a worry free and relaxing full enema. Just writing this procedure gets me really ready for my next go.

Thanks for the details on how to hook-up and insert a balloon nozzle. I've been interested in buying and trying one for some time but hesitated because of the cost and how to use the thing.

I posted a query several days ago wondering if you had to hook-up the enema source--assuming you want to use it for taking a good, long enema (and who wouldn't?!). It seems that, unless you've run water through it before inserting the first balloon--and clamped it--that air would be forced inside your butt unless you connect it to an enema bag and fill it to the tip with water first. Am I correct?

I appreciate your description of how to lube it and insert it. Think I've gotta try one. Thanks again.