Clamps

I've been turned on by enemas for a while but I just recently bought a combination douche, enema, water bottle system to use with my girlfriend. It's pretty easy to use except that I can't get the clamp to work! Any suggestions? Thanks.

It's rather odd the clamp isn't working. If that is the case you could use practically anything to pinch the hose off.

You could have either you or your girlfriend whom ever is giving the enema to use their forefinger and thumb as the clamp. Are you sure that you have inserted the hose between the bend in the clamp and the push vee lever and not over the top of the push vee lever?

The metal clamps sold in office supply stores to hold large bundles of paper work. Try the ones about two inches wide.

Most anything will work. If you have a rubber band laying around, you could kink the hose, then rubber band around that spot.

You can use a wood cloths pin for a clamp.

You can buy a new clap from bethtyler .com - try to get a sliding clamp that regulates the water flow.

A general question, if I may.

Am I confused or is this an attempt to gain points?

Well spotted, user264. The post you drew attention to was utter rubbish and has been removed in line with site policy and the offending member has been suitably advised.

In a pinch, pun intended, use a paper clamp preferably a large one that has strength. It should close off the flow. I have seen these u shaped clamps that shut down the flow of water and would work well to regulate the flow. Where to find them I can not say. I've seen them on enema websites but do not recall the sites. Suggest checking a hardware store other than the chain hardware stores. I intend to try them.