Heating the nozzle

I've never heated the nozzle but I have heated more than one bottom before the nozzle went in.

On the other side of the coin, has anyone refrigerated or put a nozzle in the freezer for a while before connecting it and inserting? Wouldn’t that increase the “pucker factor”?

On the other side of the coin, has anyone refrigerated or put a nozzle in the freezer for a while before connecting it and inserting? Wouldn’t that increase the “pucker factor”?

That would certainly work and you can do the same thing with buttplugs

I always run hot water over the nozzle to warm it before insertion just like mom did for my enemas.

I have a silver bullet nozzle that retains heat very well. I will let the nozzle soak in a sink of very hot but not scalding water for three to five minutes then lube it with soap which actually seems to cool down the nozzle a touch . Then insert the nozzle and leave it there for about two minutes before starting the water flow. A tremendous feeling that enhances my enema experience

I have a silver bullet nozzle that retains heat very well.

Do you play the William Tell Overture and wear a mask when you are taking enemas?

The Devil made me post it! Hey, it's the last day of the year!

@gwhap: On the other side of the coin, has anyone refrigerated or put a nozzle in the freezer for a while before connecting it and inserting? Wouldn’t that increase the “pucker factor”?

I've used cold cream at times and Vicks at other times to effect different feelings.

I've used cold cream at times and Vicks at other times to effect different feelings.

Vicks is like Duct Tape - the variety of uses is countless, only limited by one's imagination…..…….

I've made a few nozzles using the heat from my Oxy torch . . Does that count ?😁

I've made a few nozzles using the heat from my Oxy torch . . Does that count ?😁

Depends on how long you wait before you use them!

@gwhap

Depends on how long you wait before you use them!

Give it too much & it goes all runny 😁

I don’t heat my enema nozzle at all unless you mean putting Vick’s Salve on the nozzle!

I actually like the cold nozzles. But I had a girlfriend who did not and asked me to warm them before inserting it in her. I turned on the water in the sink for it to get warm but she had another idea. She wanted me to put it in myself while I was making her enema. We had been together for a few years and we both knew each other was safe so, why not. It worked.

I don't heat the nozzle up even during the winter (which in our house can he a bit chilly in the bedroom). My sub gets it how ever it is. Though chilling it has an appeal…to me.

Yes, I always heat the tip under hot running water. It draws the recipient's attention to that orifice (along with the presence of the intruding nozzle) and sets the anticipation even deeper into the mindset. As always, too hot can cause tissue damage, caution is necessary!

I did not heat the nozzles before use. But over time, widening my horizons, I came across Klystras models KB2, 3. Since the lubricant has always been a petroleum jelly, such a nozzle fills with it much better and more evenly. Heating is even more necessary for SNC's products, especially from the medium supply. And even at the bottom, the feeling is more pleasant when a warm object slides through it.