Inflatable plugs and nozzles

Love them because they double as a simple butt plug in a jam.

Just got mine today, glad I happened to read all the post's from the group. I'll give it a try tonight, but sounds like I'll be rooting thru my electrial parts box for some plastic tape. What great suggestions.

Switchablesusie has the right idea...the inflatable nozzle must be narrowed via a sleeve in order not to pop out. the anal muscle is a bit complicated and the pressure on both sides helps to keep it sealed with any plug device...perhaps that is why a double balloon works so well, the inner and outer inflatable bulbs press on each side of the anus, thus equalizing the pressure...I have found that a well inflated balloon is pretty hard to inadvertently expel...

How many of the members are into using this type of device?

Where is the best place to purchase an Excellant Quality Inflatable Enema Plug?

I have been looking for a while and have seen a few. Some sites say they have been Imported from Europe. Any help would be helpful.

Please give some information if you do use this on how you like the effects.

www.extremerestraints.com has it listed also.

If you mean a retention nozzle, get a double balloon from Klystra or Beth Tyler.

I was thinking of the Inflatable Butt Plug type with the tube going thru. I think you know what I mean. Thanks for responding.

I have used the inflatable plug you mentioned before. I had high hopes for it and it might have been a design flaw peculiar to the make of the inflatable butt plug nozzle i was using but, when inflated, the air in the plug crushed the tube used for the enema and disrupted flow. The more it was pumped up(compounded by my bodies internal pressure), the more it stopped the flow and it didn't have to be very big at all to stop the water completely. It was not cheap so i was very disappointed in it. There may be other brands of the same design that have a rigid uncrushable internal tube but, i haven't found one yet. Instead, like Susie suggested, i use a double inflatable retention nozzle. It fills me up more than the plug did too except for the anus itself.here is a link to a page with a plug nozzle http://www.optimalhealthnetwork.com/Enema-Retention-Inflatable-Nozzles-p/0HRetentionNozzles.htmI purchased the f2s at klystra.com and have been very satisfied with it.

I found out that most of the balloon nozzles, aren't very sturdy. In that, if you induce a very hard contraction or cramp against the inner balloon, say from a irritating enema, the inner balloon can "Push" through the ass, and you then have a big explosion of enema all over the place and a big mess to clean up. I then thought about making my own design nozzle. I used Duralin plastic for the inner nozzle tube. I then found a supplier for these model aircraft wheels, made out of black latex rubber. They have a inner hole in the middle that I pushed the plastic nozzle through. I used 2 of the balloons, one balloon for inside the ass and the other for the outside. What I like about my design is the balloons, are made out of a Very Thick latex rubber material, and when inflated up inside the ass, they won't push through the ass from a hard contraction or cramp. It stays put no matter what. Its a bit more difficult to insert, but with a good amount of KY Jelly, it goes in without too much difficulty. Nozzle is great for retention enemas such as spiked ones or cramp inducing enemas that need a little help staying in.

Would love more info on how to make your own homemade balloon nozzle with the inflatable model airplane tires.......give us some help! thanks

Yes-- I too would like to hear/see how you did it. The hard part to me is routing of the tube used to fill the tires. Would also like to know the model number of the tires and where you got them.

On topic - I once had an inflatable enema butt plug, but it didn't last for too long so i am actually disappointed. I'm hoping to ged a double balloon some day, it seems like a much better option.

I actually recently had one of these style nozzles given to me. I don't find it to be good at all. I have problems with it slipping out due to the shape. I would have to pump it up REALLY large to get it to stay in, and while I enjoy anal dilation.... it doesn't go well before or during enema play.

In a similar post to this someone suggested a simple modification to the problem of the enema butt plugs being uncomfortable and slipping out.

That suggestion was get some black electrical tape and wrap it a few times round the base where your sphincter would be.

What this does is prevent that part from expanding very far, while the rest of it inflates larger. This makes for a far more comfortable and secure fit with no leaks.

I tried it myself and can only recommend it. It makes a fairly useless plug work as it was intended.

Good thing you chose black tape...that will hide what should be cleaned off!! Stop juryrigging[airplane tires,aquarium tubing,etc and spend a few bucks for a LASTING,SAFE piece of equipment.

Try item No. 520 from Optimal Health Network. It's cheap, cleanable, reusuable. The part that goes bad first is the pillow inflator; it cracks around the edges and won't inflate the baloon.

I've never found them that reliable either. Double balloon tube is much better.

The inflateable enema butt plug from Twist My Arm works and feel great, only thing I would like to see is one with larger thru hole so as to fill at a faster flow rate. 😃 😃 enjoy big dave

I have several rubber inflatable inflatable plugs and these can be fun when in the mood. I am always careful not to over inflate them and so far not had any burst inside me!

I routinely (like always) use the double balloon-rubber one) I can relax, retain and enjoy much more. When I do my "wake up enema' controlled by a timer, it is comfortably in all night. I couldn't recommend such a thing more to all of you. gdfru

Have replaced the butt plug nozzle three times in the last fifteen years. I have been using the nozzle with a leather harness so it is held in place during intense sessions. The harness works great the strap that holds the nozzle is between my legs forcing the nozzle flange tight against my rectum and buckles in the back so I do not have the ability to un buckel it when my hands are secured.

When using a single inflatable do you insert all the way into rectum or leave the nozzle in the sphincter and inflate it?

If inserting totally must you pull back on it to make a good seal?

To respond to Tom..I'm not sure if there's another way to use a single balloon nozzle but I insert it, inflate it and pull it down a little until it's snug.

Tom, do what Grace said.

My favorite is SANDAN LLE by C'ESTBIEN. It consists of three parts of inflatable rubber sections. Both ends lock your anus from inside and outside, then expanding the middle section to make sure no space for leakage. The diameter before inflation is 45mm. They have even thinner models. This is really powerful. I don't know if they ship it oversea.

http://www.cestbien.jp/shopdetail/003001000031/

Very interesting looking retention nozzle. I would imagine with three balloons, there would be less chance of anything leaking.

Dan

Year, it's so tight that I can walk around with it connecting to irrigator through 10m long tube keep water flowing in without any concern of leakage.

So the search needs to happen.. here is what we know so far...

Pictures of it:

http://www.zity.biz/index.php?mx=gallery;ox=showalbum;ax=5571

Sites found:

cestbien.jp

They sell it under the japanese name: サンダン (which as someone below translates to: Sandanski (although some call it the SANDAN )

The problem? Although they have answered my emails (crudely translated into japanese) they don't sell overseas and don't list on ebay or amazon (even in Japan based versions of these sites) Even if I COULD get them to sell it to me (which I've been trying to do for over a year) it retails at over $300 US. Worth it though.

There is also a 'review' of sorts on 2 sites: one of which is here: http://hiptoanal.dtiblog.com/blog-entry-58.html

BUT As you can see from the photos album, there is another version made somewhere else (with a gray pump)

My search so far:

I've used the image matching service tineye and google to find a link on http://www.a-1012.com/ (now defunct) to the Japanese one. Maybe just using the small picture as a gallery lead. Although they now re-route to a new site, I see no product there. The meta data from the gray photo says it was taken in 2003... so no help there.

The black and gray one which appears to be a marketing shot has been impossible to trace so far. Originally there was a second photo of it (non inflated) that I haven't been able to find yet.

There used to also be a gallery of the toy in use.( http://www.zity.biz/index.php?action=album;sa=catshow;catid=2196) but that looks to be gone.

What I can say is this.. whoever the hell makes these needs better marketing people. I'm damn near hiring a private eye. There is CLEARLY a market for this.. and we as a community need to help find it. Please post pictures, thoughts and links to this thread and lets organize a search party.

Another lead I'm following up on.. I managed to find a profile picture of a guy in Italy (I think) using one.

https://www.xtube.com/photo.php?p=9hfsFlP1yF5

I've emailed him but not heard back yet.

I need your help! Lets find more sources and content!!!

To help the search engines find this page this block of text is to help; (since I've tried about every combination)

Triple Balloon Enema Nozzle, Triple Balloon Enema, 3 Balloon Enema Nozzle, Three Balloon Enema Nozzle, 3 Balloon Retention Nozzle

Another picture:

https://twitter.com/cestbien_sm/status/206445150191370242/photo/1

http://www.clubmyrrh.jp/data/tools/thumb/6cf61a9fdd448041c1689b9da35e6e2c.jpg

Thanks Gallonist, some really great stuff here, I need to get one, for sure!

I have had a high quality double balloon nozzle that I used for many years. I was so great because I could relax completely in any position, and it would let me take all 4 quarts without leaking. However, as I got older using this fun nozzle,and/or put bigger things in my ass, my sphincter tended to not close as tight and I started having some leakage. So, I then pumped in more air. Instead of the recommended 4 pumps, I started going to 5 or 6 pumps for the inner balloon. Well, you know what happened. On a contraction, the inner balloon burst and I had a big cleanup and I was very unhappy to loose a good friendly nozzle. I will try it in single balloon mode, but am doubtful that it will work properly.