Njoy butt plug question....

I dropped my njoy butt plug on the concrete floor. Did I damage it at all???

You're the one who can look at it.

Did you damage it?

Must not..they are quite sturdy....made of toughened glass I guess

Switchablesusie... It looks OK other than some marks on it. I don't recall them being there before but I admit I never inspected it that closely before.

sexyass... This is made of steel/stainlesssteel

I assume it is OK.. I was just looking for others opinions on it.

I would say as long as there aren't any sharp nicks or cuts in it, you should be OK. Stainless Steel isn't going to break from dropping it. If you so have nicks or cuts, just polish them out with emery cloth.

It sounds like you scratched it. It CAN NOT break.

If it is rough you may need to polish it with various grades of emery paper

Thank you much to all! I just didn't want any unexpected issues during its next use. :-)

Those darn concrete floors !ol

Jce you undoubtedly killed the little aliens inside who service it at night when you're not using it. You need to send it back to the manufacturer for recolonization.

Everyone is a comedian :-)

Let me tell you.. It was quite loud as it bounced around!

Just an update... My njoy is still awesome! 😃

Njoy butt plugs are lifetime toys !

^^^ What Susie said above. Depends whether it has any nicks or scratches. You'll want to polish those out with increasing grits of wet/dry paper or emery cloth.

Start with a fine [about 500] wet or dry emery paper designed for bodywork [car bodywork], get it smooth and then polish with crocus cloth. these items can be purchased at any auto parts store. if you want it to really shine buff it on a polishing wheel with polishing compound.

I did the same thing...slipped right out of my hand.... I have a dremel kit and it came with a cloth wheel and some abrasive paste... It took a few minutes but all damage is gone...just like new...

Unless you have a smelter in your house, you should be fine, suzie is right, Njoys are for life.

Make sure you check it for sharp edges. You don't want to cut yourself...Emery cloth (coarser to start and finish with very fine) will take the sharp edges off and make sure it's safe for you to use.

I did the same thing, and even though there were no sharp edges that I could feel with my finger, I did it anyway...just to be safe.