Making your own electrodes

Hey guys was wondering if any one out there has come across plans or a how to for building a waveform generator

Some how-to available at www.kinky-engineering.info

I tried using bare copper wire bent in half and twisted slightly. With a lot of lube I inserted it about an inch into my urethra. I attached one wire to the copper and the other to an electrode to the base of my penis. Wow! VERY intense!

I am at the SM end of the spectrum for Estim so needed electrodes that would present a lower impedance to ensure enough stimulation.

What works best for me is to take a 1" x 6" strip of ordinary kitchen aluminium foil and wrap it in a few layers of kitchen tissue. I soak this in some salty water then wind the strip around my penis, just below my glans (with foreskin retracted works best for me). Held firmly in place by an elastic band. The other electrode is a 12 x 18" sheet of the same foil, covered in a couple layers of salt water wetted kitchen tissue, which sits under my buttocks.

This provides an excellent current flow all the way down my shaft, and is felt deep inside my torso too- there is a degree of prostate stimulation with this setup, which leads to a very intense and productive orgasm.

The large surface area of both electrodes ensures that the current density at any one point is very low, ensuring no possibility of burn from a hot spot.

So a month or so ago I posted about how much I liked the Zeus bipolar prostate stimulator and wished it was more durable. I was experimenting last week after reading some of the posts and created something that made me lose interest in that device. I took an anal hook that has 32 mm ball on the end and used electrical tape to wrap everything but the ball. Close to the eyelet on the end I wrapped an e-stim patch before taping it. Now the ball is the electrode and I placed another patch at the top of the scrotum, just below my penis shaft. I used a tens machine I purchased of the internet and set it to tap, it has control for intensity as well as rate of speed. It took some playing around to find the right setting but the results were electrifying. It was the first time I had achieved an orgasm complete with ejaculation from an e-stim device. I'm in love. if your into e-stim you should try it and if you want more details or pics just ask.

Was wondering if anyone has ever tryed aluminium foil for anal electrodes.

There is an aluminum tape that is used for sealing duct work.. You can apply this to assorted non conductive toys and see what you can come up with. Cuts easily with scissors, and sticks very well.

Doc

There is an aluminum tape that is used for sealing duct work.. You can apply this to assorted non conductive toys and see what you can come up with. Cuts easily with scissors, and sticks very well.

Doc

You can also use double stick tale and aluminum foil to make mono and bipolar electrodes for the same result.

I have used sanded and polished polyurethaned 1 1/4" dowels 15 inches long, inserted 12 inches. It hits every sensory and motor nerve in and out of the cauda equina. Depending on how high to set the e-stim, can make your entire lower body tingle or go into convulsions!

Aluminum tape is awesome and is the real 'duct tape', not the crappy grey flexible stuff that always comes off at some point.

It's also an absolute essential for DIY electrode projects and is much less expensive than copper tape!

Replying to oldodo's post about using a phone plug. Tried it last night. Short, thin, left weird sensation around my prostate. Not sure what that was about. Might try again. Really looking at longer and larger diameter probes with contacts running along two opposite sides for it's full length though.

Is it possible to use a METAL butt plug as an anal electrode for a single electrode? or is it too large?

Is it possible to use a METAL butt plug as an anal electrode for a single electrode? or is it too large?

A single piece metal plug will work just fine as a monopolar electrode, meaning you will need to use it with a second electrode placed elsewhere. The larger surface area of an entirely metal plug will require higher power to feel, especially if your other electrode is smaller.

Excluding use of conductive rubber which is optimal but not strictly DIY.

For surface electrodes I suggest felt fabric pads soaked with a salty solution and secured in position with medical tape (which stick also on mucosal tissues and wet skin). They are very pleasurable for stimulation of the glans, prepuce, labia and clitoris.

As cavitary electrodes for vaginal or anal stimulation I tried several cylindrical kitchenware such as spoons and handles made of stainless steel or silver that can be easily inserted and connected to the stimulator with alligator clamps. I remember one of my best electrostimulation session done after my playdoc dilated my anus with the blunt handle of a silver punch ladle which then was used as return lead from urethral stimulation.

The man who introduced me to estim made his own anal toys. He would buy 2L soda bottles that HADN'T been filled yet. And surprisingly, those come as small and hard cylinders with rounded ends. (The soda is injected with such pressure that it expands the bottle.) He used some copper tape and would make some fun toys. And they were cheap, so each time he played with someone new he could gift them a toy.