The inflatable nozzle

Tomorrow I get my inflatable nozzle. It blows up large. Can’t wait to have it used. Will post pictures.

Curious where you are getting it from as well as if it lives up to expectation. I still have a 250/250 latex dbn and sbn from the 1980's, and I like those allot. I've read negative comments about newer silicon dbn's with the larger inner balloon.

It’s from clean stream and it’s silicone. I ordered it via Amazon.

I see lots of enema items both on Amazon and Walmart. Wow! Enema interest is doing well!

ETA also the Etsy site...

I ordered my double balloon from Optimal Health Network and agree the inner balloon is much larger than a much older version that failed with use and time.

I’ve got the same one bought on Amazon back in May

It’s had a lot of use this summer

Finally failed on me on Friday got a small hole it it

I bought some silicone super glue on Amazon and figured I try it

Working great so far

Hopefully will give it a hard try tomorrow night

I bought these a few years ago;

It was interesting to pick up the goods at customs.. 😎😂

I'll take a few pictures for the gallery.

https://www.shopcatheters.com/p-bard-rubber-rectal-catheter.html

The Clean Streams aren't bad. But they all do eventually fail. At least they're not too pricey.

I wish Silicone Nozzles would make their balloon nozzle again or come out with a new version. It was my fav until it failed and I go back to the Klystra days. Bob is leaving money on the table by not producing a decent balloon nozzle. I've emailed him a couple of times over the last couple of years about producing one again and he always replies he'll get to it but never seems to.

I wish Silicone Nozzles would make their balloon nozzle again or come out with a new version. It was my fav until it failed and I go back to the Klystra days. Bob is leaving money on the table by not producing a decent balloon nozzle. I've emailed him a couple of times over the last couple of years about producing one again and he always replies he'll get to it but never seems to.

Agree about SiliconeNozzles’ balloon nozzle. I bought one very soon after they first became available and it served me well for a good five years before finally failing. I hope Bob gets around to designing a new one.